Search results

I have 2 codes: 12-No reference pulses from distributor are reaching ECM. 42-Electronic Spark Timing is grounded or open, Malfunctioning HEI module can this. Any ideas or help would be greatly appreciated.

I know the Ty's run better with an additional heat exchanger but was curious what part number you guys are using for this? I think the stock inter coolers use a 7/8" heater hose?

I have no oil pressure and I'm pretty sure the oil pump is good. I want to test the circuit from the sensor to the gauge. I have three wires coming off the sensor- light green, yellow and orange. Any one know which wire I need to test? Most likely the cause. Thanks.

What's every one using for speaker replacements? I've been out of the scene for a while and was curious. I was always partial to pioneer or alpine. Kicker?

Just curious as to what every one is doing to when their air tube for the air filter begins to fail? Pics would be nice.

I have a RPM stage 3 turbo installed but it's making contact with the heater hose just as it connects to the radiator. What's the cure fort his? I have the 3" cobra hose on the way but would like some input. Thanks.

Morning, anyone have a good part number for the ABS Sensor/backing plate for a 92 Typhoon? The center hole for the axle is too small on the backing plate. Thanks!

Top of the morning to you! I have heard that the axles in our trucks are weak? I read some where that there was a direct bolt on from a newer s10 variant? So what I wanted to know was what should I be looking for in the junk yard for a direct bolt on replacement? Am I even correct about the...

Hey guys, trying to find a rear wheel ABS sensor but have no luck. I need one for each side, does any one have a part number or know where I can get them? Thanks!

Morning guys, just wondered if one could get his CAC rebuilt, both upper and lower? I am thinking a radiator shop could repair it but open to all inputs. Thanks!

Morning, I have chosen to order a long block from Mike at RPM and wondered where would I get my Ty tuned? Hopefully some one here can recommend a place. This site has been very helpful in research and Mike has a good reputation around here. Look forward to running with you guys once I return...

I drove my Ty today and now I have a rod knocking!! We just finished many repairs only to have a rod to start knocking but thats a hot rod for you. I was wondering where could I get a replacement engine for a Ty? Any help you guys could provide would be awesome, thanks in advance. I would like a...

Evening, I am a new Ty owner #0431 and love it. when I bought it, it needed some attention. I did a full tune up using all AC Delco parts (plugs gapped at .035), checked the timing (0 degrees) and checked full pressure (42 psi). I replaced the intake gasket and every vaccum line. We noticed the...